Front Speed Sensor: Installation
WARNING: This page is about a different car, the 2008 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
- INSTALL FRONT SPEED SENSOR LH
- Using a hexagon wrench, install the front speed sensor with the bolt.
Torque: 11 N*m (107 kgf*cm, 8 ft.*lbf)
NOTE:- Make sure that there are no pieces of iron or other foreign matter attached to the sensor tip part.
- While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip part.
- After installing the speed sensor, make sure that there is no clearance or foreign matter between the sensor stay part and the knuckle.
- Make sure that there is no foreign matter attached to the magnetic rotor.
- Connect the front speed sensor connector.
- Using a hexagon wrench, install the front speed sensor with the bolt.
- INSTALL FRONT WHEEL (See INSTALLATION )
- INSPECT SPEED SENSOR SIGNAL (See TEST MODE PROCEDURE )