Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: When replacing the VSC actuator assembly, perform zero point calibration (See CALIBRATION ).

REPLACE ECM
1. Replace the ECM for 2UZ-FE (See REMOVAL ) or 3UR-FE (See REMOVAL ).

RECONFIRM DTC

Clear the DTC (See DTC CHECK/CLEAR ).

Check if the same DTC is output (See DTC CHECK/CLEAR ).

Result

RESULT REFERENCE

Result	Proceed to
DTC is output	A
DTC is not output	B

B: END

A: REPLACE VSC ACTUATOR ASSEMBLY (See REMOVAL )