Inspection Procedure
WARNING: This page is about a different car, the 2009 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
When replacing the VSC actuator assembly, perform zero point calibration (See CALIBRATION
).
- CHECK ABS CONTROL SYSTEM
- Clear the DTC (See DTC CHECK/CLEAR ).
- Turn the ignition switch to ON.
- Check if the same DTC is recorded (See DTC CHECK/CLEAR
).
Result
RESULT REFERENCEResult Proceed to DTC (ABS control system DTC) is not output A DTC (ABS control system DTC) is output B
B: REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (ABS CONTROL SYSTEM) (See DIAGNOSTIC TROUBLE CODE CHART )
A: Go to Next Step
- CONFIRM DTC
- Clear the DTC (See DTC CHECK/CLEAR ).
- Turn the ignition switch to ON.
- Check if the same DTC is recorded (See DTC CHECK/CLEAR
).
Result
RESULT REFERENCEResult Proceed to DTC (C1223/43) is not output A DTC (C1223/43) is output B
B: REPLACE VSC ACTUATOR ASSEMBLY (See REMOVAL )
A: CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (See HOW TO PROCEED WITH TROUBLESHOOTING )