Skid Control Buzzer: Installation

WARNING: This page is about a different car, the 2009 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL SKID CONTROL BUZZER ASSEMBLY
1. Connect the buzzer connector.
  NOTE: Securely connect the connector.
2. Attach the clamp to install the buzzer.
  NOTE:
  - Securely insert the clamp into the bracket of the instrument panel reinforcement.
  - If the buzzer is dropped, replace it.
    
    Fig 1: Identifying Skid Control Buzzer Assembly
    Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH (See INSTALLATION )
INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (See INSTALLATION )
INSTALL INSTRUMENT SIDE PANEL LH (See INSTALLATION )
INSTALL COWL SIDE TRIM BOARD LH (See INSTALLATION )
INSTALL FRONT DOOR SCUFF PLATE LH (See INSTALLATION )