Confirmation Driving Pattern

WARNING: This page is about a different car, the 2009 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Performing this confirmation pattern will activate the catalyst monitor. This is very useful for verifying the completion of a repair.

Fig 1: Vehicle Speed Driving Pattern

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Clear DTCs (if set).
Enter the following menus: Powertrain/Engine and ECT/Monitor.
Check that Catalyst/Status 2 is Incomplete.
Start the engine and warm it up.
Drive the vehicle at between 40 mph and 70 mph (64 km/h and 113 km/h) for at least 10 minutes.
Those items will change to Complete as Catalyst monitor operates.
Enter the following menus: Powertrain/Engine and ECT/Trouble Codes/Pending.
Check if any DTCs (any pending DTCs) are set.
HINT:

If Catalyst does not change to Complete, and any pending DTCs fail to set, extend the driving time.