Confirmation Driving Pattern

WARNING: This page is about a different car, the 2009 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Performing this confirmation pattern will activate the A/F sensor response monitor.

Fig 1: Vehicle Speed Driving Pattern

Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Clear DTCs (if set).
Select the following menu items: Powertrain/Engine and ECT/Monitor/O2 Sensor/Details.
Check that RES RATE B1S1 is incomplete.
Start the engine and warm it up.
Drive the vehicle at between 25 mph and 75 mph (40 km/h and 120 km/h) for 3 minutes. However, the vehicle should be driven at a constant speed.
Check the test result values on the Techstream by selecting the following menu items: Powertrain/Engine and ECT/Monitor/O2 Sensor.
If the values indicated on the Techstream do not change, perform READINESS MONITOR DRIVE PATTERN for the A/F sensor and the heated oxygen sensor (See READINESS MONITOR DRIVE PATTERN ).
HINT:

Completion of all A/F sensor monitors is required to change the value in Test Result.
Note the value of the Monitor Result.
Select the following menu items: Powertrain/Engine and ECT/Trouble Codes/Pending.
Check if any DTCs (any pending DTCs) are set.