Steering Angle Sensor: Installation

INSTALL SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY
1. Install the spiral with sensor cable sub-assembly (See INSTALLATION ).
  NOTE:
  - Do not replace the spiral cable with the battery connected and the engine switch on (IG).
  - Do not rotate the spiral cable with the battery connected and the engine switch on (IG).
  - Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
  - Do not remove the steering sensor from the spiral cable.
  - Never use the steering angle sensor detached from spiral cable.
  HINT:
  
  The steering angle sensor is a component of the spiral with sensor cable sub-assembly. If the steering angle sensor malfunctions, replace the spiral with sensor cable sub-assembly.
INSTALL UPPER STEERING COLUMN COVER (See INSTALLATION )
INSTALL LOWER STEERING COLUMN COVER (See INSTALLATION )
ADJUST SPIRAL CABLE (See INSTALLATION )
INSTALL STEERING WHEEL ASSEMBLY (See INSTALLATION )
INSPECT STEERING WHEEL CENTER POINT
INSTALL STEERING PAD (See INSTALLATION )
INSTALL LOWER NO. 3 STEERING WHEEL COVER (See INSTALLATION )
INSTALL LOWER NO. 2 STEERING WHEEL COVER (See INSTALLATION )
INSPECT STEERING PAD (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See INITIALIZATION ).
INSPECT SRS WARNING LIGHT (See DIAGNOSIS SYSTEM )