Inspection Procedure
- CHECK CAN COMMUNICATION SYSTEM
- Check if a CAN communication system DTC is output (See
DIAGNOSIS SYSTEM
).
Result
RESULT CHARTResult Proceed to DTC is not output A DTC is output B B: INSPECT CAN COMMUNICATION SYSTEM (See HOW TO PROCEED WITH TROUBLESHOOTING )
A: Go to next step
- Check if a CAN communication system DTC is output (See
DIAGNOSIS SYSTEM
).
- PERFORM ENGINE VARIANT LEARNING
- Perform engine variant learning (See CALIBRATION
).
HINT:
- Engine variant learning is automatically performed immediately after the Test Mode is entered.
- If learning has not yet been performed, the ABS warning and slip indicator lights will remain on and DTC C1288/88 will be stored.
- Perform engine variant learning (See CALIBRATION
).
- RECONFIRM DTC
- Turn the ignition switch off.
- Clear the DTCs (See DTC CHECK / CLEAR ).
- Start the engine.
- Check if the same DTC is recorded (See DTC CHECK / CLEAR
).
Result
RESULT CHARTResult Proceed to DTC (C1288/88) is not output A DTC (C1288/88) is output (for 2GR-FE) B DTC (C1288/88) is output (for 1AR-FE) C B: REPLACE ECM (for 2GR-FE) (See REMOVAL )
C: REPLACE ECM (for 1AR-FE) (See REMOVAL )
A: END