LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2009 >> Venza 2.7 E, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control/Dynamic Control System >> Vehicle Stability Control System >> Diagnostic Trouble Code Chart
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnostic Trouble Code Chart

NOTE: Turn the ignition switch off before removing any parts.

HINT:

ABS DTC 

ABS DIAGNOSTIC TROUBLE CODE CHART

DTC Code Detection Item Trouble Area
C0200/31 *1 Front Speed Sensor RH Circuit
  1. Front speed sensor RH
  2. Speed sensor circuit
  3. Speed sensor rotor
  4. Sensor installation
  5. Brake actuator assembly (Skid control ECU)
C0205/32 *1 Front Speed Sensor LH Circuit
  1. Front speed sensor LH
  2. Speed sensor circuit
  3. Speed sensor rotor
  4. Sensor installation
  5. Brake actuator assembly (Skid control ECU)
C0210/33 *1 Rear Speed Sensor RH Circuit
  1. Rear speed sensor RH
  2. Speed sensor circuit
  3. Speed sensor rotor
  4. Sensor installation
  5. Brake actuator assembly (Skid control ECU)
C0215/34 *1 Rear Speed Sensor LH Circuit
  1. Rear speed sensor LH
  2. Speed sensor circuit
  3. Speed sensor rotor
  4. Sensor installation
  5. Brake actuator assembly (Skid control ECU)
C0226/21  SFR Solenoid Circuit
  1. SFRR or SFRH circuit
  2. Brake actuator assembly (SFR solenoid)
C0236/22  SFL Solenoid Circuit
  1. SFLR or SFLH circuit
  2. Brake actuator assembly (SFL solenoid)
C0246/23  SRR Solenoid Circuit
  1. SRRR or SRRH circuit
  2. Brake actuator assembly (SRR solenoid)
C0256/24  SRL Solenoid Circuit
  1. SRLR or SRLH circuit
  2. Brake actuator assembly (SRL solenoid)
C0273/13 *1 Open or Short Circuit in ABS Motor Relay Circuit
  1. Fusible link block (ABS NO. 1 fuse)
  2. ABS motor relay circuit
  3. Brake actuator assembly (ABS motor relay)
C0278/11  Open or Short Circuit in ABS Solenoid Relay Circuit
  1. Fusible link block (ABS NO. 2 fuse)
  2. ABS solenoid relay circuit
  3. Brake actuator assembly (ABS solenoid relay)
C1225/25  SM Solenoid Circuit
  1. SRM1 circuit
  2. Brake actuator assembly (SRM1 solenoid)
C1226/26  SRM Solenoid Circuit
  1. SRM2 circuit
  2. Brake actuator assembly (SRM2 solenoid)
C1227/27  SRC Solenoid Circuit
  1. SRC1 circuit
  2. Brake actuator assembly (SRC1 solenoid)
C1228/28  SRC Solenoid Circuit
  1. SRC2 circuit
  2. Brake actuator assembly (SRC2 solenoid)
C1237/37  Speed Sensor Rotor Faulty
  1. Tire and wheel size
  2. Tire deformation
  3. Speed sensor rotor
  4. Speed sensor
  5. Speed sensor circuit
  6. Brake actuator assembly (Skid control ECU)
C1241/41  Low Battery Positive Voltage or Abnormally High Battery Positive Voltage
  1. ECU-IG NO.2 fuse
  2. Battery
  3. Charging system
  4. Power source circuit
  5. Internal power supply circuit of the skid control ECU
C1245/45 *3 Acceleration Sensor Output Malfunction
  1. Sensor installation
  2. Yaw rate and acceleration sensor
C1246/46 *2 Master Cylinder Pressure Sensor Malfunction
  1. Stop light switch circuit
  2. Master cylinder pressure sensor circuit
  3. Brake actuator assembly (Master cylinder pressure sensor)
C1249/49  Open in Stop Light Switch Circuit
  1. STOP fuse
  2. Stop light switch
  3. Stop light switch circuit
  4. Stop light control (BRK) relay
  5. Stop light control (BRK) relay circuit
  6. Brake actuator assembly (Skid control ECU)
C1267/67  Brake Pedal Load Sensing Switch
  1. Brake pedal load sensing switch
  2. Brake pedal load sensing switch circuit
C1288/88  ECU Version Miss Match ECM
C1300/62  Skid Control ECU Malfunction Brake actuator assembly (Skid control ECU)
C1330/35  Right Front Speed Sensor Circuit
  1. Front speed sensor RH
  2. Speed sensor circuit
  3. Sensor installation
C1331/36  Left Front Speed Sensor Circuit
  1. Front speed sensor LH
  2. Speed sensor circuit
  3. Sensor installation
C1332/38  Right Rear Speed Sensor Circuit
  1. Rear speed sensor RH
  2. Speed sensor circuit
  3. Sensor installation
C1333/39  Left Rear Speed Sensor Circuit
  1. Rear speed sensor LH
  2. Speed sensor circuit
  3. Sensor installation
U0124/95  Lost Communication with Lateral Acceleration Sensor Module CAN communication system (Skid control ECU to yaw rate and acceleration sensor)
U0073/94  Control Module Communication Bus OFF CAN communication system
*1, 2: Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed:
  • *1:
    1. Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.
    2. Clear the DTCs.
  • *2:
    1. Keep the vehicle stationary for 5 seconds or more and depress the brake pedal lightly 2 or 3 times.
    2. Drive the vehicle at a speed of 50 km/h (31 mph) and keep depressing the brake pedal strongly for approximately 3 seconds.
    3. Repeat the above operation 3 times or more and check that the ABS warning light goes off.
    4. Clear the DTCs.

*3: for AWD

HINT:

In some cases, the Techstream cannot be used when the ABS warning light remains on.

VSC DTC 

VSC DIAGNOSTIC TROUBLE CODE CHART

DTC Code Detection Item Trouble Area
43  ABS Control System Malfunction ABS control system
C0365/28  Malfunction in Deceleration Sensor
  1. Yaw rate and acceleration sensor
  2. Yaw rate and acceleration sensor circuit
  3. Sensor installation
  4. Brake actuator assembly (Skid control ECU)
C1201/51  Engine Control System Malfunction Engine control system
C1231/31  Steering Angle Sensor Circuit Malfunction
  1. Steering angle sensor
  2. Steering angle sensor circuit
  3. Steering angle sensor power supply
  4. Brake actuator assembly (Skid control ECU)
C1234/34  Yaw Rate Sensor Malfunction
  1. Yaw rate and acceleration sensor
  2. Yaw rate and acceleration sensor circuit
C1245/32 (1) Acceleration Sensor Output Malfunction
  1. Sensor installation
  2. Yaw rate and acceleration sensor
C1380/64  Stop Light Control Relay Malfunction
  1. Stop light switch
  2. Stop light switch circuit
  3. Stop light control (BRK) relay
  4. Stop light control (BRK) relay circuit
  5. Brake actuator assembly (Skid control ECU)
C1439/31  Steering Angle Sensor Initialization Incomplete
  1. Steering angle sensor
  2. Yaw rate and acceleration sensor
  3. Brake actuator assembly (Skid control ECU)
C1445/31  Vehicle Driven with Steering Angle Sensor not Initialized
  1. Steering angle sensor
  2. Yaw rate and acceleration sensor
  3. Brake actuator assembly (Skid control ECU)
C1448/98  Yaw Rate Sensor Output Malfunction Yaw rate and acceleration sensor
U0100/65  Lost Communication with ECM / PCM CAN communication system (Skid control ECU to ECM)
U0123/62  Lost Communication with Yaw Rate Sensor Module CAN communication system (Skid control ECU to yaw rate and acceleration sensor)
U0126/63  Lost Communication with Steering Angle Sensor Module CAN communication system (Skid control ECU to steering angle sensor)
(1) for 2WD

HINT:

In some cases, the Techstream cannot be used when the slip indicator light remains on.

ABS Test Mode DTC 

ABS TEST MODE DIAGNOSTIC TROUBLE CODE CHART

DTC Code Detection Item Trouble Area
C1271/71  Low Output Signal of Front Speed Sensor RH (Test Mode DTC)
  1. Front speed sensor RH
  2. Sensor installation
  3. Speed sensor rotor
C1272/72  Low Output Signal of Front Speed Sensor LH (Test Mode DTC)
  1. Front speed sensor LH
  2. Sensor installation
  3. Speed sensor rotor
C1273/73  Low Output Signal of Rear Speed Sensor RH (Test Mode DTC)
  1. Rear speed sensor RH
  2. Sensor installation
  3. Speed sensor rotor
C1274/74  Low Output Signal of Rear Speed Sensor LH (Test Mode DTC)
  1. Rear speed sensor LH
  2. Sensor installation
  3. Speed sensor rotor
C1275/75  Abnormal Change in Output Signal of Front Speed Sensor RH (Test Mode DTC) Speed sensor rotor
C1276/76  Abnormal Change in Output Signal of Front Speed Sensor LH (Test Mode DTC) Speed sensor rotor
C1277/77  Abnormal Change in Output Signal of Rear Speed Sensor RH (Test Mode DTC) Speed sensor rotor
C1278/78  Abnormal Change in Output Signal of Rear Speed Sensor LH (Test Mode DTC) Speed sensor rotor
C1281/81  Master Cylinder Pressure Sensor Output Malfunction (Test Mode DTC)
  1. Stop light switch
  2. Brake pedal load sensing switch
  3. Master cylinder pressure sensor