Steering Pad Switch: Installation

WARNING: This page is about a different car, the 2009 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL STEERING PAD SWITCH LH
1. Connect the connector.
2. Attach the 2 claws to install the steering pad switch.
  
  Fig 1: Identifying Steering Pad Switch Claws - LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL STEERING PAD SWITCH RH
1. Connect the connector.
2. Attach the 2 claws to install the steering pad switch.
INSTALL STEERING PAD ASSEMBLY (See INSTALLATION )
INSTALL NO. 2 STEERING WHEEL COVER LOWER
INSTALL NO. 3 STEERING WHEEL COVER LOWER
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Fig 2: Identifying Steering Pad Switch Claws - RH
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
PERFORM INITIALIZATION
1. Perform initialization (see INITIALIZATION ).
  NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.
INSPECT STEERING PAD ASSEMBLY (See ON-VEHICLE INSPECTION )
CHECK SRS WARNING LIGHT (See CHECK MODE PROCEDURE )