Power Window Control System: Initialization
WARNING: This page is about a different car, the 2009 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
- RESET (INITIALIZE) POWER WINDOW REGULATOR MOTOR (for Driver Side) NOTE: Resetting the power window regulator motor (initializing the pulse sensor) is necessary if: 1) the battery terminal cable is disconnected; 2) the power window regulator master switch assembly, wire harness, power window regulator switch, power window regulator assembly and power window regulator motor are replaced or removed / installed; or 3) the PWR H-fuse, FR DOOR fuse, GAUGE fuse and ECU-IG fuse are replaced. If resetting is not performed, the master switch assembly will not be able to operate the AUTO operation function, jam protection function and remote UP / DOWN function.
- *1: Turn the power switch ON (IG).
- *2: Open the power window halfway by pressing the power window switch.
- *3: Fully pull up on the switch until the power window is fully closed and continue to hold the switch for at least 1 second.
- *4: Check that the AUTO UP / DOWN function operates normally.
If the AUTO UP / DOWN function operates normally, reset operations are complete. If abnormal, follow steps below.
- Disconnect the negative (-) battery terminal cable for 10 seconds.
- Connect the battery terminal cable.
- Perform steps *1 to *4 again.