LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2010 >> Camry Base, Standard >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Smart Key System (Keyless Entry) (Diagnostics & Circuit Tests) (Except Hybrid) >> Smart Key System >> Circuit Tests >> Certification ECU Power Source Circuit >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Certification ECU Power Source Circuit: Procedure

  1. CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) 
    1. Disconnect the E58 certification ECU connector.
      Fig 1: Checking Harness And Connector (Power Source Circuit)
      GTY169217Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the voltage according to the value(s) in the table below.

      Standard voltage

      Tester Connection (Symbols) Condition Specified Condition
      E58-1 (+B) - Body ground Always 10 to 14 V
      E58-18 (IG) - Body ground Engine switch OFF Below 1 V
      Engine switch ON (IG) 10 to 14 V
      E58-19 (ACC) - Body ground Engine switch OFF Below 1 V
      Engine switch ON (ACC) 10 to 14 V
    3. Measure the resistance according to the value(s) in the table below.

      Standard resistance

      Tester Connection (Symbols) Condition Specified Condition
      E58-17 (E) - Body ground Always Below 1 Ω

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

scientia non olet · About LEMON Manuals