Rear Door RH Entry Unlock Function does not Operate: Procedure

1. When the master switch assembly door control switch is operated, check that the locked doors unlock.

   OK

   Door locks operate normally.

NG → See step   10 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Main Body / Data List.
5. Read the Data List according to the display on the Techstream.
   MAIN BODY
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   RR-Door Lock Pos SW	Passenger side rear door lock position switch signal / ON or OFF	ON: Passenger side rear door unlocked OFF: Passenger side rear door locked	-

   OK

   On the Techstream screen, the display changes between ON and OFF as shown in the chart above.

NG → See step   12 

OK: Go to next step 

1. Using the Techstream, read the Data List.
   SMART KEY
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   Pr-Door Touch Sensor	Passenger side rear door touch sensor / ON or OFF	ON: Touch sensor touched OFF: Touch sensor not touched	-

   OK

   "ON" (sensor is touched) and "OFF" (sensor is not touched) appears on the screen.

NG → See step   4 

OK → See step   11 

1. Disconnect the E30 ECU connector.
   Fig 1: Identifying Certification ECU And Door Electrical Key Oscillator Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the z26 oscillator connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E30-2 (SEL4) - z26-4 (SEL)	Always	Below 1 Ω
   E30-27 (SEN4) - z26-6 (SENS)	Always	Below 1 Ω
   E30-2 (SEL4) - Body ground	Always	10 kΩ or higher
   E30-27 (SEN4) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Disconnect the z25 handle connector.
   Fig 2: Identifying Door Electrical Key Oscillator And Rear Door Outside Handle Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the z26 oscillator connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   z25-6 (SGT) - z26-2 (SGT)	Always	Below 1 Ω
   z25-6 (SGT) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Replace the door electrical key oscillator. Refer to DISASSEMBLY - Step 37 .

NEXT: Go to next step 

1. Check that the entry function operates normally.

   OK

   Operates normally.

NG → See step   8 

OK → END (DOOR ELECTRICAL KEY OSCILLATOR IS DEFECTIVE) 

1. Replace the rear door outside handle. Refer to DISASSEMBLY - Step 28 .

NEXT: Go to next step 

1. Check that the entry function operates normally.

   OK

   Operates normally.

NG → See step   11 

OK → END (REAR DOOR OUTSIDE HANDLE IS DEFECTIVE)