LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2010 >> Matrix Base, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Engine Fuel System (2ZR-FE) (Service Information) >> Fuel Sender Gauge Assembly >> Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Sender Gauge Assembly: Installation: Installation

  1. INSTALL FUEL SENDER GAUGE ASSEMBLY 
    1. Install the fuel sender gauge assembly by sliding it downward.
      Fig 1: Identifying Fuel Sender Gauge Assembly (2WD)
      GTY189082Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Do not damage the wire harness.

    2. Connect the connector of the fuel sender gauge assembly.
      NOTE:

      Make sure that the fuel sender gauge arm does not bend.

  2. INSTALL FUEL SUCTION TUBE ASSEMBLY 
    1. Install the fuel suction tube assembly to the fuel tank assembly . Refer to REASSEMBLY .
  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  4. INSPECT FOR FUEL LEAK  . Refer to ON-VEHICLE INSPECTION - Step 1
scientia non olet · About LEMON Manuals