Steering Wheel: Installation: Installation

INSTALL STEERING WHEEL PAD ATTACHING SCREW
1. Install the 2 steering wheel pad attaching screws to the lower steering wheel boss cover.
  
  Fig 1: Identifying Steering Pad Attaching Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL LOWER STEERING WHEEL BOSS COVER
1. Engage the 2 claws to install the lower steering wheel boss cover to the steering wheel sub-assembly.
  
  Fig 2: Identifying Lower Steering Wheel Boss Cover Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the 2 screws.
  
  Fig 3: Identifying Lower Steering Wheel Boss Cover Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System) . Refer to INSTALLATION - Step 1
INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Navigation System) . Refer to INSTALLATION - Step 2
INSTALL STEERING PAD SWITCH LH (w/ Steering Pad Switch) . Refer to INSTALLATION - Step 1
INSTALL NO. 1 STEERING WHEEL ORNAMENT (w/ Steering Pad Switch)
1. Engage the 2 pins to install the No. 1 steering wheel ornament to the steering wheel sub-assembly.
  
  Fig 4: Identifying No. 1 Steering Wheel Ornament Pins
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the screw.
  
  Fig 5: Identifying No. 1 Steering Wheel Ornament Screw (W/ Steering Pad Switch)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
TURN FRONT WHEELS TO FACE STRAIGHT AHEAD
ADJUST SPIRAL CABLE . Refer to INSTALLATION - Step 25
INSTALL STEERING WHEEL ASSEMBLY
1. Align the matchmarks on the steering wheel assembly and steering main shaft.
  
  Fig 6: Identifying Matchmarks On Steering Wheel Assembly And Steering Main Shaft
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the steering wheel assembly set nut.
  Torque: 50 N*m (510 kgf*cm, 37 ft.*lbf)
3. Connect the connectors to the spiral cable sub-assembly.
INSTALL STEERING PAD . Refer to INSTALLATION - Step 1
INSTALL LOWER NO. 3 STEERING WHEEL COVER . Refer to INSTALLATION - Step 2
INSTALL LOWER NO. 2 STEERING WHEEL COVER . Refer to INSTALLATION - Step 3
INSPECT STEERING WHEEL CENTER POINT
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
- Make sure that the cable has been disconnected from the battery terminal for at least 2 seconds before reconnecting the cable.
- Connect the cable to the negative (-) battery terminal with the front wheels facing straight ahead.
INSPECT STEERING PAD . Refer to INSTALLATION - Step 5
INSPECT SRS WARNING LIGHT
HINT:

Refer to DIAGNOSIS SYSTEM .