DTC P0106: Manifold Absolute Pressure / Barometric Pressure Circuit Range / Performance Problem: Procedure
- CHECK ANY OTHER DTC OUTPUT (IN ADDITION TO P0106)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG) and turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTCs.RESULT
Result Proceed to DTC P0106 is output A DTC P0106 and other DTCs are output B HINT:
If any DTCs other than P0106 are output, troubleshoot those DTCs first.
B → See step 6
A: Go to next step
- READ VALUE USING TECHSTREAM (MANIFOLD ABSOLUTE PRESSURE SENSOR)
- Connect the Techstream to the DLC3.
- Put the engine in inspection mode. Refer to INSPECTION MODE PROCEDURE .
- Start the engine and warm it up.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Data List / MAP.
- Read the MAP value at idling and 2500 rpm.
Standard
Engine condition Tester Display Power switch on (IG) 80 to 110 kPa Idling 28 to 48 kPa 2500 rpm 22 to 50 kPa
NG → See step 3
OK → See step 5
- CHECK INTAKE SYSTEM
- Check the intake system for vacuum leaks. Refer to ON-VEHICLE INSPECTION
.
OK
No leaks in the intake system.
NG → REPAIR OR REPLACE INTAKE SYSTEM
OK → See step 4
- Check the intake system for vacuum leaks. Refer to ON-VEHICLE INSPECTION
.
- REPLACE MANIFOLD ABSOLUTE PRESSURE SENSOR. Refer to REMOVAL
- CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS
- GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART