LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2010 >> Prius Base >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control (SFI) System (Diagnostic Codes (P0300-P106A)) (Except PHV) >> SFI System >> DTC P050A: Cold Start Idle Air Control System Performance >> Typical Enabling Conditions
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Typical Enabling Conditions

Monitor runs whenever following DTCs are not present P0010 (VVT Oil Control Valve Bank 1)
P0011 (VVT System Bank 1- Advance)
P0012 (VVT System Bank 1- Retard)
P0016 (VVT System Bank 1 - Misalignment)
P0102, P0103 (Mass Air Flow Meter)
P0107, P0108 (Manifold Absolute Pressure)
P0115, P0117, P0118 (Engine Coolant Temperature Sensor)
P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135 (Throttle Position Sensor)
P0125 (Insufficient Engine Coolant Temperature for Closed Loop Fuel Control)
P0171, P0172 (Fuel System)
P0301, P0302, P0303, P0304 (Misfire)
P0335 (Crankshaft Position Sensor)
P0340, P0342, P0343 (Camshaft Position Sensor)
P0351, P0352, P0353, P0354 (Igniter)
P0401 (EGR System (Closed))
P2195, P2196, P2237, P2238, P2239, P2252, P2253, P2A00 (Air Fuel Ratio Sensor - Sensor 1)
Battery voltage 8 V or more
Time after engine start 0 second or more
Starter OFF
Engine coolant temperature at engine start -10°C (14°F) or more
Engine coolant temperature -10 to 50°C (14 to 122°F)
Engine idling time 3 second or more
Fuel-cut OFF
Vehicle speed Less than 37.5 mph (60 km/h)
Atmospheric pressure 76 kPa (570 mmHg) or more