LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2010 >> Prius PHV >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control (SFI) System (Diagnostic Codes (P0327-P1451)) (PHV) >> SFI System >> DTC P060B: Internal Control Module A/D Processing Performance >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC P060B: Internal Control Module A/D Processing Performance: Procedure

  1. READ OUTPUT DTC (DTC P060B) 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Clear the DTCs. Refer toDTC CHECK / CLEAR .
    5. Turn the power switch off.
    6. Turn the Techstream off.
    7. Disconnect the Techstream.
    8. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
    9. Connect the cable to the negative (-) battery terminal.
    10. Connect the Techstream to the DLC3.
    11. Turn the power switch on (IG).
    12. Wait 16 seconds or more.
    13. Turn the Techstream on.
    14. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
    15. Read the DTCs.

      Result

      Result Proceed to
      DTC is not output A
      DTC P060B is output B
      DTC P060B and P0327 or P0328 are output C

    C → See step   4 

    B → See step   3 

    A → See step   2 

  2. CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS 
  3. REPLACE ECM. Refer to REMOVAL 
  4. GO TO DTC (P0327 AND P0328). Refer to DTC P0327: Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor); DTC P0328: Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor)  
scientia non olet · About LEMON Manuals