April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure: Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK FOR DTC
1. Clear the DTC. Refer to DTC CHECK / CLEAR .
2. Turn the power switch on (IG).
3. After 330 seconds have elapsed, check if the DTC has been set again.
  OK
  
  DTC B2277 is not output
  
  HINT:
  
  If there are any signs that water was present, before replacing the power management control ECU, take measures to prevent any further water entry.
NG → See step 2

OK → See step 3
REPLACE POWER MANAGEMENT CONTROL ECU. Refer to REMOVAL
USE SIMULATION METHOD TO CHECK. Refer to HOW TO PROCEED WITH TROUBLESHOOTING