Diagnostic Trouble Code Chart
WARNING: This page is about a different variant/trim than selected.
| DTC No. | Detection Item | Trouble Area | See |
|---|---|---|---|
| C1241/94 | Low Power Supply Voltage | -Battery -generator -ECU-IG1 -Wire harness -4WD control ECU |
Refer to DTC C1241/94: Low Power Supply Voltage |
| C1280/82 | Engine Circuit Malfunction | -Throttle position sensor -Throttle position sensor wire harness and connector -CAN communication system |
Refer to DTC C1280/82: Engine Circuit Malfunction |
| C1296/96 | ABS Malfunction | -Wire harness -4WD control ECU -Skid control ECU -Speed sensor -Yaw rate sensor -CAN communication system |
Refer to DTC C1296/96: ABS Malfunction |
| C1297/97 | Steering Angle Sensor | -Steering angle sensor -CAN communication system -Wire harness -4WD control ECU |
Refer to DTC C1297/97: Steering Angle Sensor |
| C1298/98 | Linear Solenoid Circuit | -Wire harness -Electromagnetic coupling -4WD control ECU |
Refer to DTC C1298/98: Linear Solenoid Circuit |
| C1299/99 | Cancellation of 4WD Control | -Tire size -Electromagnetic coupling -4WD control ECU |
Refer to DTC C1299/99: Cancellation of 4WD Control |
| U0073/86 | Control Module Communication Bus OFF | -Wire harness (CANH, CANL circuit) -4WD control ECU |
Refer to DTC U0073/86: Control Module Communication Bus OFF; DTC U0100/85: Lost Communication with ECM / PCM "A"; DTC U0126/84: Lost Communication with Steering Angle Sensor Module; DTC U0129/83: Lost Communication with Brake System Control Module |
| U0100/85 | Lost Communication with ECM / PCM "A" | -Wire harness (CANH, CANL circuit) -4WD control ECU -ECM |
Refer to DTC U0073/86: Control Module Communication Bus OFF; DTC U0100/85: Lost Communication with ECM / PCM "A"; DTC U0126/84: Lost Communication with Steering Angle Sensor Module; DTC U0129/83: Lost Communication with Brake System Control Module |
| U0126/84 | Lost Communication with Steering Angle Sensor Module | -Wire harness (CANH, CANL circuit) -4WD control ECU -Steering angle sensor |
Refer to DTC U0073/86: Control Module Communication Bus OFF; DTC U0100/85: Lost Communication with ECM / PCM "A"; DTC U0126/84: Lost Communication with Steering Angle Sensor Module; DTC U0129/83: Lost Communication with Brake System Control Module |
| U0129/83 | Lost Communication with Brake System Control Module | -Wire harness (CANH, CANL circuit) -4WD control ECU -Skid control ECU |
Refer to DTC U0073/86: Control Module Communication Bus OFF; DTC U0100/85: Lost Communication with ECM / PCM "A"; DTC U0126/84: Lost Communication with Steering Angle Sensor Module; DTC U0129/83: Lost Communication with Brake System Control Module |