SFI System: Precaution: Precaution
WARNING: This page is about a different car, the 2010 Toyota FJ Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- INITIALIZATION NOTE:
- Perform initialization (throttle position) after replacing the throttle with motor body assembly or cleaning any throttle body components. Refer to INSTALLATION - Step 6 .
- Perform initialization (throttle position) after reconnecting the battery cable or replacing the ECM. Refer to INSTALLATION - Step 6 .
- Perform the RESET MEMORY (AT initialization) when replacing the automatic transmission assembly, engine assembly or ECM. Refer to INITIALIZATION .
- Perform the REGISTRATION (VIN registration) when replacing the ECM. Refer to REGISTRATION .
- If the ECM has been replaced or RESET MEMORY (AT initialization) has been performed, set up the function of the ATF (Automatic Transmission Fluid) temperature warning light. Refer to INITIALIZATION .
HINT:
Initialization cannot be completed by only removing the battery.
- FOR USING TECHSTREAM WARNING:
Observe the following items for safety reasons:
- Read its instruction books before using the Techstream.
- Prevent the Techstream cable from being caught on the pedals, shift lever and steering wheel when driving with the Techstream connected to the vehicle.
- When driving the vehicle for testing purposes using the tester, two persons are required. One is for driving the vehicle, and the other operates the Techstream.