Inner Rear View Mirror Power Source Circuit (FROM 12/2010): Procedure
- CHECK HARNESS AND CONNECTOR (BATTERY - INNER REAR VIEW MIRROR ASSEMBLY)
- Disconnect the N9 connector from the inner rear view mirror assembly.
- Measure the voltage according to the value(s) in the table below.
Standard Voltage
Tester Connection Switch Condition Specified Condition N9-1 (IG) - N9-2 (E) Ignition switch ON 11 to 14 V Ignition switch off Below 1 V
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → See step 2
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE