How To Proceed With Troubleshooting

HINT: 

Use the following procedure to troubleshoot the rear view monitor system.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. CUSTOMER PROBLEM ANALYSIS 

   NEXT: Go to next step 

3. INSPECT BATTERY VOLTAGE 

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

   NEXT: Go to next step 

4. PROBLEM SYMPTOM CONFIRMATION 
   RESULT
   
   

   Result	Proceed to
   Symptom does not occur	A
   Symptom occurs	B

   B → Go to step  6 

   A: Go to next step 

5. SYMPTOM SIMULATION 

   NEXT: Go to next step 

6. PROBLEM SYMPTOMS TABLE 
   1. Refer to PROBLEM SYMPTOMS TABLE .
      RESULT
      
      

      Result	Proceed to
      Fault is not listed in Problem Symptoms Table	A
      Fault is listed in Problem Symptoms Table	B

      B → Go to step  8 

      A: Go to next step 

7. PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM 
   1. Refer to TERMINALS OF ECU .

      NEXT: Go to next step 

8. ADJUST, REPAIR OR REPLACE 

   NEXT: Go to next step 

9. CONFIRMATION TEST 

   NEXT → END