Installation (To 12/2010): Installation
- INSTALL CRUISE CONTROL MAIN SWITCH
- Install the cruise control main switch assembly with the 2 screws.
Torque: 2.35 N*m (24 kgf*cm, 21 in.*lbf)
- Connect the connector.
- Install the cruise control main switch assembly with the 2 screws.
- INSTALL STEERING PAD . Refer to INSTALLATION - Step 1
- CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
- PERFORM INITIALIZATION NOTE:
Some systems need initialization when disconnecting the cable from the negative battery terminal. Refer to INITIALIZATION .
- INSPECT STEERING PAD . Refer to INSTALLATION - Step 5
- INSPECT SRS WARNING LIGHT
Refer to CHECK MODE PROCEDURE