Installation (To 12/2010): Installation

1. Install the front speed sensor with the bolt.
   Fig 1: Locating Front Speed Sensor Bolt

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Torque: 8.5 N*m (87 kgf*cm, 75 in.*lbf) 

   NOTE:

   Prevent foreign matter from attaching to the sensor tip.

2. Install the sensor harness brackets with the 2 bolts to the body and shock absorber assembly.
   Fig 2: Sensor Harness Brackets And Fasteners

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Bolt A 

   Torque: 5.0 N*m (51 kgf*cm, 44 in.*lbf) 

   Bolt B 

   Torque: 19 N*m (192 kgf*cm, 14 ft.*lbf) 

3. Connect the clamp to the steering knuckle.
   NOTE:

   Do not twist the wire harness for front speed sensor when installing the speed sensor.

4. Connect the speed sensor connector and clamp.
   Fig 3: Locating Speed Sensor Connector And Clamp

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Torque: 103 N*m (1,050 kgf*cm, 76 ft.*lbf) 

1. Check for the speed sensor signal. Refer to TEST MODE PROCEDURE .