LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2011 >> Avalon Base >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Emission Control System (Service Information) >> Canister >> Installation (From 12/2010) >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation (From 12/2010): Installation

  1. INSTALL CHARCOAL CANISTER ASSEMBLY 
    1. Install the 2 bolts, clip and charcoal canister.

      Torque: 36 N*m (367 kgf*cm, 27 ft.*lbf) 

    2. Connect the purge line hose to the charcoal canister.
    3. Connect the wire harness clamp.
    4. Connect the vapor pressure sensor connector.
    5. Connect the charcoal canister filter sub-assembly to the charcoal canister.
    6. Connect the fuel tank vent hose to the charcoal canister.
  2. INSTALL FUEL TANK ASSEMBLY  . Refer to INSTALLATION - Step 1
  3. INSTALL PARKING BRAKE CABLE ASSEMBLY NO. 3  . Refer to INSTALLATION - Step 3
  4. INSTALL PARKING BRAKE CABLE ASSEMBLY NO. 2  . Refer to INSTALLATION - Step 4
  5. INSTALL EXHAUST PIPE ASSEMBLY CENTER 
  6. CONNECT FUEL PUMP TUBE SUB-ASSEMBLY 
  7. ADD FUEL 
  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  9. CHECK FOR FUEL LEAKS 
  10. INSPECT FOR EXHAUST GAS LEAK 
  11. INSTALL REAR FLOOR SERVICE HOLE COVER 
  12. INSTALL REAR SEAT CUSHION ASSEMBLY 
scientia non olet · About LEMON Manuals