Driver Side Door Entry Lock Function does not Operate: Procedure

1. When the master switch assembly door control switch is operated, check that the locked doors unlock.

   OK

   Door locks operate normally.

NG → See step   8 

OK: Go to next step 

1. Using the Techstream, read the Data List.
   SMART KEY
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   D-Door Trigger Switch	Driver side door outside handle lock switch / ON or OFF	ON: Entry lock switch pushed OFF: Entry lock switch not pushed	-

   OK

   On Techstream screen, item changes between ON and OFF according to above chart.

NG → See step   3 

OK → See step   10 

1. Disconnect the z24 oscillator connector.
   Fig 1: Identifying Front Door Outside Handle And Door Electrical Key Oscillator Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the z23 handle connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   z24-9 (TRG-) - z23-1 (TRG-)	Always	Below 1 Ω
   z24-9 (TRG-) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Disconnect the E29 ECU connector.
   Fig 2: Identifying Certification ECU And Front Door Outside Handle Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the z23 handle connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   E29-3 (TSW1) - z23-3 (TRG+)	Always	Below 1 Ω
   E29-3 (TSW1) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Measure the resistance according to the value(s) in the table below.
   Fig 3: Identifying Front Door Outside Handle Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Resistance

   Tester Connection	Switch Condition	Specified Condition
   z23-1 (TRG-) - z23-3 (TRG+)	Lock switch not pushed	10 kΩ or higher
   	Lock switch pushed	Below 1 Ω

NG → See step   9 

OK: Go to next step 

1. Replace the door electrical key oscillator, refer to DISASSEMBLY - Step 37 .

NEXT: Go to next step 

1. Check that the entry function operates normally.

   OK

   Operates normally.

NG → See step   10 

OK → END (DOOR ELECTRICAL OSCILLATOR IS DEFECTIVE)