LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2011 >> Matrix Base, Automatic >> Repair and Diagnosis (Single Page) >> External Pages >> Different variant/trim >> Section 14 (Engine Control System (2AZ-FE) (Service Information)) >> Crankshaft Position Sensor >> Removal >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Crankshaft Position Sensor: Removal: Removal

WARNING: This page is about a different variant/trim than selected.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE ENGINE UNDER COVER RH 
  3. REMOVE V-RIBBED BELT  . Refer to REMOVAL - Step 2
  4. REMOVE GENERATOR ASSEMBLY  . Refer to REMOVAL - Step 4
  5. REMOVE CRANKSHAFT POSITION SENSOR 
    1. Disconnect the crankshaft position sensor connector.
      Fig 1: Remove/Install Crank Position Sensor Connector
      GTY177970Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Separate the crankshaft position sensor connector clamp and wire harness.
    3. Remove the bolt and crankshaft position sensor.
scientia non olet · About LEMON Manuals