LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2011 >> Matrix Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Steering Lock System (Diagnostics - Introduction)) >> Steering Lock System >> Data List / Active Test >> Data List / Active Test
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List / Active Test

WARNING: This page is about a different car, the 2011 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. DATA LIST 

    HINT: 

    Using Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Turn the engine switch off.
    2. Connect Techstream to the DLC3.
    3. Turn the engine switch on (IG).
    4. Turn Techstream on.
    5. Enter the following menus: Body / Main Body / Data List.
    6. According to the display on the tester, read the "Data List".
      MAIN BODY:

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Key SW Unlock warning switch signal / ON or OFF ON: Key is in ignition key cylinder
      OFF: No key is in ignition key cylinder      		 -
      IG SW Ignition switch signal / ON or OFF ON: Ignition switch ON or START
      OFF: Ignition switch ACC or OFF      		 -
      +B Power source / Break or Normal Break: Power source open
      Normal: Power source normal      		 -
      Antenna Coil Status Transponder key amplifier coil condition / Normal or Fail Normal: Antenna coil is normal
      Fail: Antenna coil is malfunctioning      		 -
  2. ACTIVE TEST 

    HINT: 

    Using Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Turn the engine switch off.
    2. Connect Techstream to the DLC3.
    3. Turn the engine switch on (IG).
    4. Turn Techstream on.
    5. Enter the following menus: Body / Main Body / Active Test.
    6. According to the display on the tester, read the "Active Test".
      MAIN BODY:

      Tester Display Test Part Control Range Diagnostic Note
      Security Indicator Security indicator light ON / OFF -
scientia non olet · About LEMON Manuals