Data List / Active Test

HINT: 

Using Techstream Data List allows switch, sensor, actuator and other item values to be read without removing any parts. Reading the Data List early in troubleshooting is one way to shorten labor time.

1. Connect Techstream to the DLC3.
2. Turn the ignition switch ON.
3. Turn the tester on.
4. Enter the following menus: Body Electrical / Immobilizer / Data List.
5. Read the Data List according to the display on the tester.
   IMMOBILIZER:
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   KEY SW	Unlock warning switch signal/ON or OFF	ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder	-
   IG SW	Ignition switch signal/ON or OFF	OFF: Ignition switch is OFF or ACC position ON: Ignition switch is in the ON position	-
   Immobilizer	Immobilizer system status/SET or UNSET	UNSET: Without key SET: Ignition switch ON	-
   Permit (Start)	Permit (Start) signal/OK or NG	NG: No permission for engine start OK: Engine start permission	-
   Response	Transponder chip data/NG or OK	NG: Data error OK: Data OK	-
   Frame Error	Transponder chip data/NG or OK	NG: Data error OK: Data OK	-
   Different Serial Number	Transponder chip data/NG or OK	NG: Data error OK: Data OK	-
   Different Encrypt Code	Transponder chip data/NG or OK	NG: Data error OK: Data OK	-
   Abnormal Status	Transponder chip data/NG or OK	NG: Data error OK: Data OK	-
   Bcc Malfunction	Transponder chip signal/NG or OK	NG: Incorrect data sending OK: Correct data sending	-
   Sub Key	Sub-key code signal/NOMATCH or MATCH	NOMATCH: Unmatched sub-key code is sent MATCH: Sub-key code is sent	-
   Master Key	Master key code signal/NOMATCH or MATCH	NOMATCH: Unmatched Master key code is sent MATCH: Master key code is sent	-
   Transponder S-Code	Number of registered sub-key/min. 0, max. 15	Number of registered sub-key	-
   Transponder M-Code	Number of registered master key/min. 0, max. 15	Number of registered master key	-
   Reg Code Space Full	Memory space for key codes registration/NOT FUL or FULL	NOT FUL: Possible to register more key codes FULL: Cannot register any more key codes	-
   +B	Power source/BREAK or NORMAL	BREAK: Power source open Normal: Power source normal	-
   Antenna Coil Status	Transponder key amplifier coil condition/NORMAL or FAIL	Normal: Antenna coil is normal FAIL: Antenna coil is malfunctioning	-

HINT: 

Performing Techstream Active Test allows relay, VSV, actuator and other items to be operated without removing any parts. Performing the Active Test early in troubleshooting is one way to shorten the labor time. The Data List can be displayed during the Active Test.

1. Connect Techstream to the DLC3.
2. Turn the ignition switch ON.
3. Turn the tester on.
4. Enter the following menus: Body Electrical / Immobilizer / Active Test.
5. Perform the Active Test according to the display on the tester.
   IMMOBILIZER:
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Security Indic	Turn security indicator	ON/OFF	-