Typical Enabling Conditions
ALL
| Monitor runs whenever following DTCs are not present | None |
AFTER ENGINE STOP
| Time after engine start | 10 seconds or more |
| Battery voltage | 10.5 V or more |
| Intake air temperature sensor circuit | OK |
| Engine coolant temperature sensor circuit | OK |
| Mass air flow meter circuit | OK |
| Engine coolant temperature before engine stop | 70°C (158°F) or more |
| Time that mass air flow is low before engine stop | 2100 seconds or more |
| Accumulated mass air flow amount before engine stop | 1864 g or more |
| Key-off duration | 30 minutes |
AFTER COLD ENGINE START
| Key-off duration | 5 hours or more |
| Time after engine start | 10 seconds or more |
| Intake air temperature sensor circuit | OK |
| Engine coolant temperature sensor circuit | OK |
| Mass air flow meter circuit | OK |
| Engine coolant temperature | 70°C (158°F) or more |
| Accumulated mass air flow amount | 1864 g or more |
| Either of following conditions 1 or 2 is met: | - |
| 1. Duration while engine load is low | 120 seconds or more |
| 2. Duration while engine load is high | 10 seconds or more |