Air Fuel Ratio Sensor: Installation: Installation

WARNING: This page is about a different variant/trim than selected.

INSTALL AIR FUEL RATIO SENSOR
1. Using SST, install the air fuel ratio sensor.
  
  Fig 1: Installing Air Fuel Ratio Sensor Using SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  - SST: 09224-00010
  without SST
  
  Torque: 44 N*m (449 kgf*cm, 32 ft.*lbf)
  
  with SST
  
  Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf)
  NOTE:
  - The "with SST" torque value is effective when SST is parallel to the torque wrench.
  - The "with SST" torque value can be obtained by using a torque wrench with a fulcrum length of 300 mm (11.8 in.) and SST with a measurement of 30 mm (1.18 in.). Refer to PRECAUTION .
2. Connect the air fuel ratio sensor connector and clamp.
INSTALL NO. 2 CYLINDER HEAD COVER . Refer to INSTALLATION - Step 85
INSTALL OUTER COWL TOP PANEL . Refer to INSTALLATION - Step 19
INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY . Refer to INSTALLATION - Step 3
INSTALL COWL TOP VENTILATOR LOUVER LH . Refer to INSTALLATION - Step 4
INSTALL COWL TOP VENTILATOR LOUVER RH . Refer to INSTALLATION - Step 5
INSTALL HOOD TO COWL TOP SEAL . Refer to INSTALLATION - Step 6
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY RH . Refer to INSTALLATION - Step 7
INSTALL FRONT WIPER ARM AND BLADE ASSEMBLY LH . Refer to INSTALLATION - Step 8
INSTALL FRONT WIPER ARM HEAD CAP . Refer to INSTALLATION - Step 9
INSPECT FOR EXHAUST GAS LEAK