How To Proceed With Troubleshooting

HINT: 

• Use the procedure to troubleshoot the power door lock control system.
• *: Use Techstream.

1. VEHICLE BROUGHT TO WORKSHOP 

   NEXT: Go to next step 

2. INSPECT BATTERY VOLTAGE 

   Standard voltage

   11 to 14 V

   If the voltage is below 11 V, recharge or replace the battery before proceeding.

   NEXT: Go to next step 

3. PROBLEM SYMPTOMS TABLE 
   RESULT
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed on problem symptoms table	B

   B → Go to step   5 

   A: Go to next step 

4. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. Refer to OPERATION CHECK .
   2. Refer to TERMINALS OF ECU .
   3. Refer to DATA LIST / ACTIVE TEST .

      NEXT: Go to next step 

5. ADJUST, REPAIR OR REPLACE 

   NEXT: Go to next step 

6. CONFIRMATION TEST 

   NEXT → END