Downhill Assist Control Switch: Inspection: Inspection

CHECK DOWNHILL ASSIST CONTROL SWITCH

Measure the resistance according to the value(s) in the table below.

Fig 1: Identifying Downhill Assist Control Switch Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard Resistance

Tester Connection	Switch Condition	Specified Condition
1 - 4	Not pushed	10 kΩ or higher
1 - 4	Pushed in	Below 25 Ω

If the result is not as specified, replace the switch.

Apply battery voltage and check the illumination operation.

Measurement Condition	Specified Condition
Battery positive (+) → Terminal 3 Battery negative (-) → Terminal 2	Bulb illuminates

If the result is not as specified, replace the switch.