LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2011 >> RAV4 Base, 2.5 F, AWD >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Lock System (Diagnostic Codes & Circuit Tests) >> Steering Lock System >> Circuit Tests >> Power Source Circuit >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Source Circuit: Procedure

  1. INSPECT FUSE (STR LOCK) 
    1. Remove the STR LOCK fuse from the engine room relay block.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      STR LOCK fuse Always Below 1 Ω

    NG → REPLACE FUSE 

    OK: Go to next step 

  2. CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - BATTERY) 
    Fig 1: Identifying Steering Lock ECU Connector Terminals (Battery)
    GTY235637Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the E77 ECU connector.
    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage

      Tester Connection Condition Specified Condition
      E77-7 (B) - Body ground Always 11 to 14 V

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: Go to next step 

  3. CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - BODY GROUND) 
    Fig 2: Identifying Steering Lock ECU Connector Terminals (Body Ground)
    GTY226729Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Disconnect the E77 ECU connector.
    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition
      E77-1 (GND) - Body ground Always Below 1 Ω
      E77-2 (SGND) - Body ground Always Below 1 Ω

    NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK → See step   4 

  4. GO TO STEERING LOCK SYSTEM  PROBLEM SYMPTOMS TABLE 
scientia non olet · About LEMON Manuals