Installation (To 12/2010): Installation

INSTALL STEERING SENSOR

Fig 1: Locating Steering Sensor At Spiral Cable Claw
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Install the steering sensor onto the spiral cable.
  NOTE:
  - Engage the claws securely.
  - Be careful not to damage the claws.
REMOVE PLACE FRONT WHEELS FACING STRAIGHT AHEAD
INSTALL SPIRAL CABLE . Refer to INSTALLATION - Step 2
CENTER SPIRAL CABLE . Refer to INSTALLATION - Step 3
INSTALL STEERING COLUMN COVER UPPER . Refer to INSTALLATION - Step 4
INSTALL STEERING COLUMN COVER LOWER . Refer to INSTALLATION - Step 5
INSTALL STEERING WHEEL ASSEMBLY . Refer to INSTALLATION - Step 21
INSTALL STEERING PAD ASSEMBLY . Refer to INSTALLATION - Step 1
INSTALL STEERING WHEEL COVER LOWER NO. 3 . Refer to INSTALLATION - Step 23
INSTALL STEERING WHEEL COVER LOWER NO. 2 . Refer to INSTALLATION - Step 24
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
INSPECT STEERING PAD ASSEMBLY
INSPECT SRS WARNING LIGHT
Refer to DIAGNOSIS SYSTEM