Center Airbag Sensor Assembly: Installation: Installation

INSTALL AIRBAG SENSOR ASSEMBLY
1. Turn the ignition switch off.
2. Disconnect the cable from the negative (-) battery terminal.
  WARNING:
  Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
  
  NOTE:
  When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
3. Install the airbag sensor with the 3 bolts.
  Torque: 18 N*m (184 kgf*cm, 13 ft.*lbf)
  NOTE:
  - If the airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
  - When installing the airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
4. Check that the airbag sensor is not loose.
5. Connect the connector.
INSTALL REAR CONSOLE BOX ASSEMBLY
1. Install the rear console box assembly. Refer to INSTALLATION .
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .
CHECK SRS WARNING LIGHT
1. Check the SRS warning light. Refer to DIAGNOSIS SYSTEM .