DTC P0101: Mass Air Flow Circuit Range / Performance Problem: Procedure
- CHECK FOR ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0101)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Code.
- Read DTCs.RESULT
Display (DTC Output) Proceed to P0101 A P0101 and other DTCs B HINT:
If any DTCs other than P0101 are output, troubleshoot those DTCs first.
B → See step 4
A: Go to next step
- CHECK AIR INDUCTION SYSTEM
- Check the air induction system for vacuum leakage.
OK
No leakage from air induction system.
NG → See step 5
OK: Go to next step
- Check the air induction system for vacuum leakage.
- CHECK PCV HOSE CONNECTIONS
- Check the PCV hose connections.
OK
PCV hose is connected correctly and is not damaged.
NG → See step 6
OK → See step 7
- Check the PCV hose connections.
- GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART
- REPAIR OR REPLACE AIR INDUCTION SYSTEM. Refer to REMOVAL
- REPAIR OR REPLACE PCV HOSE. Refer to REMOVAL
- REPLACE MASS AIR FLOW METER. Refer to REMOVAL