Power Window Master Switch Power Source Circuit: Procedure

1. Disconnect the H6 connector.
2. Measure the resistance and voltage according to the value(s) in the table below.

   Standard resistance

   Tester Connection	Condition	Specified Condition
   H6-2 (E) - Body ground	Always	Below 1 Ω

   Standard voltage

   Tester Connection	Condition	Specified Condition
   H6-10 (PWR) - Body ground	Always	11 to 14 V
   H6-20 (IG) - Body ground	Ignition switch OFF → ON	Below 1 V → 11 to 14 V

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN  PROBLEM SYMPTOMS TABLE