DTC P2121: Throttle / Pedal Position Sensor / Switch "D" Circuit Range / Performance: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine / Trouble Codes.
5. Read the DTCs.

   Result

   Result	Proceed to
   DTC P2121 is output	A
   DTC P2121 and other DTCs are output	B

   HINT: 

   If any DTC other than P2121 are output, troubleshoot those DTCs first.

B → See step   5 

A: Go to next step 

1. Connect Techstream to the DLC3.
   Fig 1: Identifying Accelerator Pedal Depressed And Released Position

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Turn the ignition switch to ON and turn the Techstream on.
3. Enter the following menus: Powertrain / Engine / Data List / All Data / Accel Sensor Out No. 1 and Accel Sensor Out No. 2.
4. Read the values displayed on the Techstream.

   Standard voltage

   Accelerator Pedal Operations	Accel Sensor Out No. 1	Accel Sensor Out No. 2
   Fully Released	0.5 to 1.1 V	1.2 to 2.0 V
   Fully Depressed	2.6 to 4.5 V	3.4 to 4.98 V

NG → See step   3 

OK → See step   6 

1. Replace the accelerator pedal assembly. Refer to REMOVAL .

NEXT: Go to next step 

1. Connect Techstream to the DLC3.
2. Turn the ignition switch to ON and turn the Techstream on.
3. Clear the DTCs. Refer to DTC CHECK / CLEAR .
4. Start the engine.
5. Drive the vehicle in accordance with the driving pattern described in the Confirmation Driving Pattern.
6. Enter the following menus: Powertrain / Engine / Trouble Codes.
7. Read the DTCs.

   Result

   Result	Proceed to
   DTC P2121 is output	A
   DTC is not output	B

B → END 

A → See step   7