DTC B1795: Occupant Classification ECU Malfunction: Procedure

1. Turn the ignition switch on (IG), and wait for at least 10 seconds.
2. Check the DTCs. Refer to DTC CHECK / CLEAR .

   Result

   A 

   DTC B1771 and B1795 are output.

   B 

   DTC B1795 is output.

   HINT: 

   Codes other than DTC B1771 and B1795 may be output at this time, but they are not related to this check.

A → GO TO  DTC B1771: Passenger Side Buckle Switch Circuit Malfunction  

B: Go to next step 

1. Turn the ignition switch off.
2. Disconnect the negative (-) terminal cable from the battery.
3. Replace the occupant classification ECU. Refer to DTC CHECK / CLEAR .

NEXT: Go to next step 

1. Connect the negative (-) terminal cable to the battery.
2. Connect the Techstream to the DLC3.
3. Turn the ignition switch on (IG).
4. Using the Techstream, perform "Zero point calibration". Refer to INITIALIZATION .

   OK

   The "Zero Point Calibration is complete." is displayed.

NEXT: Go to next step 

1. Using the Techstream, perform "Sensitivity check". Refer to INITIALIZATION .

   Standard value

   27 to 33 kg (59.52 to 72.75 lb)

NEXT → END