DTC B2276: ACCR Signal Circuit Malfunction: Procedure

1. Delete the DTC. Refer to DTC CHECK / CLEAR .

   HINT: 

   After all DTCs are cleared, check if the trouble occurs again 50 seconds after the engine switch is turned on (IG).

2. Check for DTCs again.

   OK

   No DTC is output.

NG → See step   2 

OK → END 

1. Measure the voltage according to the value(s) in the table below.
   Fig 1: Inspecting D44 Power Source Control ECU Connector Terminal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Voltage

   Terminal No. (Symbol)	Condition	Specified condition
   D44-31 (CTSW) - Body ground	Brake pedal depressed, Ignition switch START	Below 1 V

   HINT: 

   Voltage is output only when the engine is cranking.

NG → See step   4 

OK: Go to next step 

1. Disconnect the D44 ECU connector.
   Fig 2: View Of Disconnected D44 ECU Connector Terminal

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the A55 ECM connector.
   Fig 3: Identifying A55 ECM Connector Terminals

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Measure the resistance according to the value(s) in the table below.

   Resistance

   Terminal No. (Symbol)	Specified condition
   D44-31 (CTSW) - A55-13 (ACCR)	Below 1 Ω
   D44-31 (CTSW) - Body ground	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. After replacing the power source control ECU with a normally functioning ECU, check that the engine starts.

   OK

   Engine can start normally.

NG → GO TO  SFI SYSTEM 

OK → END (POWER SOURCE CONTROL ECU DEFECTIVE)