Front Passenger Side Power Window Switch Power Source Circuit: Procedure
- CHECK WIRE HARNESS (MULTIPLEX NETWORK SWITCH - BATTERY AND BODY GROUND)
- Disconnect the G6 connector.
- Measure the resistance and voltage according to the value(s) in the table below.
Standard resistance
Tester Connection Condition Specified Condition G6-7 (E) - Body ground Always Below 1 Ω Standard voltage
Tester Connection Condition Specified Condition G6-12 (BDRJ) - Body ground Always 11 to 14 V
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE