Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated): Procedure

PERFORM INITIALIZATION (DRIVER DOOR WINDOW MOTOR)
1. Initialize the power window regulator motor assembly LH (for driver door). Refer to INITIALIZATION .
NEXT: Go to next step
CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (FOR DRIVER DOOR))
1. Check that the driver door power window moves when the auto up and down functions of the power window regulator master switch assembly are operated. Refer to OPERATION CHECK .
  OK
  
  Driver door power window auto up and down function is normal.
NG → See step 3

OK → END (PROBLEM DUE TO INITIALIZATION FAILURE)
CHECK WINDOW GLASS SLIDING MOVEMENT (FOR DRIVER DOOR)
1. Remove the window regulator.
2. Install the window glass onto the door glass run.
3. Check if the door window regulator operates smoothly.
4. Check that the window glass slides smoothly when sliding it up by hand.
  OK
  
  Door window glass slides smoothly.
  
  HINT:
  
  Ensure the following:
  - The window glass fits with the glass run without improper contact or deformation.
  - Foreign objects are not caught in the glass run.
  WARNING:
  Perform initialization again.
NG → FIT WINDOW GLASS CORRECTLY (REMOVE FOREIGN OBJECTS CAUSING IMPROPER FIT OR REPLACE PARTS)

OK → See step 4
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (FOR DRIVER DOOR). Refer to REMOVAL .