Jam Protection Function does not Operate: Procedure

PERFORM INITIALIZATION (DRIVER DOOR WINDOW MOTOR)
1. Initialize the power window regulator motor assembly LH (for driver door). Refer to INITIALIZATION .
NEXT: Go to next step
CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION (FOR DRIVER DOOR))
1. Check if the power window auto up and down function operate normally. Refer to OPERATION CHECK .
  OK
  
  Driver door auto up and down function is normal.
NG → See step 4

OK: Go to next step
CHECK JAM PROTECTION FUNCTION OPERATING RANGE
1. Check if the jam protection function operates normally for the driver door power window.
  HINT:
  
  The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.
  
  OK
  
  Jam protection function operates normally.
NG → See step 5

OK → END (PROBLEM DUE TO INITIALIZATION FAILURE)
GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table). Refer to PROBLEM SYMPTOMS TABLE .
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (FOR DRIVER DOOR). Refer to REMOVAL .