Power Windows do not Operate Using All Window Switch: Procedure
- CHECK HARNESS AND CONNECTOR (POWER WINDOW MASTER SWITCH ASSEMBLY - BATTERY AND BODY GROUND)
- Disconnect the power window regulator master switch assembly connector.
- Measure the voltage and resistance according to the value(s) in the table below.
Standard Voltage
Tester Connection Condition Specified Condition K11-6 (B) - Body ground Ignition switch ON 11 to 14 V Standard Resistance
Tester Connection Condition Specified Condition K11-1 (E) - Body ground Always Below 1 Ω
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: Go to next step
- REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
- Replace the power window regulator master switch assembly. Refer to REMOVAL .
NEXT: Go to next step
- CHECK POWER WINDOW CONTROL SYSTEM
- Check the power windows operation by using the power window regulator master switch assembly and power window regulator switch assemblies.
OK
All power windows operate normally.
NG → See step 4
OK → END (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WAS DEFECTIVE)
- Check the power windows operation by using the power window regulator master switch assembly and power window regulator switch assemblies.
- REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to REMOVAL .