Specifications Index
CAMRY SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SERVICE DATA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Axle Nut/Hub Nut | |||
| Front | 294 N.m (217 ft lbs) | ||
| Rear Hub / Bearing Assembly | 60 N.m (44 ft lbs) | ||
| Battery | SERVICE DATA
(2AR-FE) SERVICE DATA (2GR-FE) |
||
| Brakes | |||
| Bleeding Sequence | BLEEDING | ||
| Disc/Drum Brakes | Front: SERVICE DATA Rear: SERVICE DATA |
||
| Torque | Front: TORQUE SPECIFICATIONS Rear: TORQUE SPECIFICATIONS |
||
| Charging | |||
| 2AR-FE | |||
| Generator | SERVICE DATA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 2GR-FE | |||
| Generator | SERVICE DATA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Drive Belts | |||
| 2AR-FE | |||
| Adjustment | ON-VEHICLE INSPECTION | ||
| Belt Routing | INSTALLATION | ||
| 2GR-FE | |||
| Adjustment | ON-VEHICLE INSPECTION | ||
| Belt Routing | INSTALLATION | ||
| Engine Cooling | |||
| 2AR-FE | |||
| General Service Specifications | SERVICE DATA | ||
| Radiator Cap Pressure | Standard Value 93.3 to 122.7 kPa (.95 to 1.25 kgf/cm2 , 13.5 to 17.8 psi) Minimum Standard value 78.5 kPa (0.8 kgf/cm2 , 11.4 psi) |
||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| 2GR-FE | |||
| General Service Specifications | SERVICE DATA | ||
| Radiator Cap Pressure | Standard Value 93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2 , 13.5 to 17.8 psi) Minimum Standard value 78.5 kPa (0.8 kgf/cm2 , 11.4 psi) |
||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| 2AR-FE | |||
| Compression | SERVICE DATA | ||
| Oil Pressure | 30 kPa (0.3 kgf/cm2
, 4.4 psi) or more at 4, 00 RPM, 260 kPa (2.7 kgf/cm2 , 38 psi) or more |
||
| Overhaul | SERVICE DATA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 2GR-FE | |||
| Compression | SERVICE DATA | ||
| Oil Pressure | at idle, 30 kPa (0.3 kgf.cm2
, 4.4 psi) or more at 3, 00 RPM, 200 (2.0 kgf.cm2 , 29 psi) or more |
||
| Overhaul | SERVICE DATA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | ||
| Flywheel/Flex plate (Drive Plate) Torque | |||
| 2AR-FE | 98 N.m (72 ft.lb.) | ||
| 2GR-FE | 83 N.m (61 ft.lb.) | ||
| Fuel System | |||
| 2AR-FE | |||
| Pressure Specification | 304 to 343 kPa (3.1 to 3.5 kgf/cm2 , 44 to 50 psi) | ||
| Fuel Pressure Test Procedure | ON-VEHICLE INSPECTION | ||
| Fuel Filter Location | FUEL PUMP | ||
| 2GR-FE | |||
| Pressure Specification | 380 to 420 kPa (3.9to 4.3kgf/cm2 , 55 to 61 psi) | ||
| Fuel Pressure Test Procedure | ON-VEHICLE INSPECTION | ||
| Fuel Filter Location | FUEL PUMP | ||
| Ignition | |||
| Firing Order & Cylinder Identification | |||
| 2AR-FE & 2GR-FE | FIRING ORDER & CYLINDER IDENTIFICATION |
||
| Spark Plug | |||
| 2AR-FE | |||
| Type | DENSO SK16HR11 | ||
| Gap | Standard electrode gap:1.0 - 1.1 mm (0.039 - 0.043 in.) Maximum electrode gap:1.3 mm (0.051 in.) |
||
| Torque | 25 N.m (255 kgf*cm, 18 ft. lbs) | ||
| 2GR-FE | |||
| Type | DENSO FK20HR11 | ||
| Gap | Standard electrode gap:1.0 - 1.1 mm (0.039 - 0.043 in.) Maximum electrode gap:1.4 mm (0.055 in.) |
||
| Torque | 18 N.m (184 kgf.cm, 13 ft. lbs) | ||
| Starting | |||
| 2AR-FE | |||
| Starter | SERVICE DATA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| 2GR-FE | |||
| Starter | SERVICE DATA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Front & Rear | |||
| Adjustment Specifications | SERVICE DATA | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 103 N.m (1, 50 kgf.cm, 76 ft lbs.) | ||