Driver Side Power Window does not Operate with Power Window Master Switch: Procedure

1. Disconnect the H7 power window regulator master switch assembly connector.
   Fig 1: Identifying Master Switch Assembly Connector - Power Relay And Ground

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Turn the ignition switch to ON.
3. Measure the voltage and resistance according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Switch Condition	Specified Condition
   H7-15 (B) - Body ground	Ignition switch ON	11 to 14 V

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H7-7 (E) - Body ground	Always	Below 1 Ω

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Power Window Regulator Master Switch Assembly)

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Inspect the power window regulator master switch assembly. Refer to INSPECTION .

NG → See step   4 

OK: Go to next step 

1. Disconnect the H7 power window regulator master switch assembly connector.
2. Disconnect the H3 power window regulator motor assembly LH connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H7-12 (D) - H3-1 (D)	Always	Below 1 Ω
   H7-10 (U) - H3-2 (U)	Always	Below 1 Ω
   H7-12 (D) or H3-1 (D) - Body ground	Always	10 kΩ or higher
   H7-10 (U) or H3-2 (U) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   5