LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2012 >> Matrix Base, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Audio / Video System (Diagnostic Codes & Symptom Tests) >> Audio And Visual System >> DTC CB-45: USB Communication Error; DTC CB-46: iPod Control Error; DTC CB-47: iPod Communication Error >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC CB-45: USB Communication Error; DTC CB-46: iPod Control Error; DTC CB-47: iPod Communication Error: Procedure

  1. CHECK CONNECTION METHOD 
    1. Check the method used to connect the USB device or "iPod" to the No. 1 stereo jack adapter assembly.

      Result

      Condition Proceed to
      USB device or "iPod" is connected using a connection cable. A
      USB device is directly connected. B

    B → See step   5 

    A: Go to next step 

  2. REPLACE CONNECTION CABLE 
    1. Disconnect the USB device or "iPod" and connection cable from the No. 1 stereo jack adapter assembly.
    2. Turn the ignition switch off.

      HINT: 

      When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

    3. Turn the ignition switch to ACC.
    4. Connect a known good connection cable to the No. 1 stereo jack adapter assembly and connect the USB device or "iPod" to the connection cable.

    NEXT: Go to next step 

  3. CLEAR DTC 
    1. Clear the DTCs. Refer to DTC CHECK / CLEAR .

    NEXT: Go to next step 

  4. CHECK DTC 
    1. Recheck for DTCs and check if the same DTC is output again.

      HINT: 

      If DTCs are detected frequently, replace the multi-media interface ECU.

      OK

      No DTCs are output.

    NG → See step   5 

    OK → END (CONNECTION CABLE WAS DEFECTIVE) 

  5. REPLACE USB DEVICE OR "iPod" 
    1. Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.
    2. Turn the ignition switch off.

      HINT: 

      When one of these DTCs has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

    3. Turn the ignition switch to ACC.
    4. Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

      HINT: 

      If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.

    NEXT: Go to next step 

  6. CLEAR DTC 
    1. Clear the DTCs. Refer to DTC CHECK / CLEAR .

    NEXT: Go to next step 

  7. RECHECK FOR DTC 
    1. Recheck for DTCs and check if the same DTC is output again.

      HINT: 

      If DTCs are detected frequently, replace the multi-media interface ECU.

      OK

      No DTCs are output.

    NG → See step   8 

    OK → USB DEVICE OR "iPod" WAS DEFECTIVE 

  8. REPLACE MULTI-MEDIA INTERFACE ECU. Refer to  REMOVAL