LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2012 >> Matrix Base, Automatic Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> Fuel Delivery >> Fuel System (2ZR-FE) (Service Information) >> Fuel Sender Gauge Assembly >> Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Sender Gauge Assembly: Installation: Installation

  1. INSTALL FUEL SENDER GAUGE ASSEMBLY 
    1. Install the fuel sender gauge assembly by sliding it downward.
      Fig 1: Identifying Fuel Sender Gauge Assembly (2WD)
      GTY189082Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:

      Do not damage the wire harness.

    2. Connect the connector of the fuel sender gauge assembly.
      NOTE:

      Make sure that the fuel sender gauge arm does not bend.

  2. INSTALL FUEL SUCTION TUBE ASSEMBLY 
    1. Install the fuel suction tube assembly to the fuel tank assembly. Refer to INSTALLATION .
  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  4. INSPECT FOR FUEL LEAK  . Refer to ON-VEHICLE INSPECTION - Step 1
scientia non olet · About LEMON Manuals